Updating a meade 497 controller instructions new top online dating

I cannot seem to bypass the Testing Motors function and attempt to reset the Autostar handset. As soon as i plug it into the Computer Control board with the batteries and the two motors I get the following: c07 Meade 43E A U T O S T A R Press 0 to Align or MODE for Menu So i press MODE Immediately i get Motor Unit Fault and then a long series of messages about why i may be getting the fault. Moving the handbox between scopes, low battery levels, obstructed or overloaded scopes can cause the failure.Press MODE to leave this message." First thing i did was replace the batteries with 10 brand new AA Energizer batteries i bought at Kroger today. I read around and found some posts on weasner that some people may have been having trouble with the cable, so i tried plugging it in with a little force behind it and now i get past the motor fault message, but it always gets stuck at the "Testing Motors" prompt, and the motors never move.Try a soft reset first if not follow Weasners guide for hard reset via software (terminal) I was never able to get to the menu to do a reset through the handset. Now that I got past that its just stuck on the testing motors prompt but it never moves the motors.there is apparently no ay to bypass the testing motors function.I assume that ill have to do it with the pc and the cable I'm making today. You may need the Meade #505 connector cable kit, if you need to do the hard reset.

I cannot seem to bypass the Testing Motors function and attempt to reset the Autostar handset. I had an ETX80 that I wanted to get a 497 for and as soon as I plugged it in, Poof, never to work again. It's simply plugged into a 492 kit with the motors and the battery case. When you say "poof" never to work again, do you mean it wouldn't even work on a different telescope?

I believe you can further update the controller to a 43Eg. With this cable connected i get the same sequence of events as i described above, but when it gets to the part where it would say testing motors the screen goes blank and still, the motors do not move.

Meade Autostar Support Page Regards, Ok i got all the necessary components to make the HBX cable and the 505 cable. So instead of saying "Testing Motors" It now says nothing.

Immediately after the Welcome to Autostar screen it just goes blank.

However, just for grins...after i did a reset with the old HBX cable, I turned the unit off.

Search for updating a meade 497 controller instructions:

updating a meade 497 controller instructions-20updating a meade 497 controller instructions-75updating a meade 497 controller instructions-19

Press MODE to leave this message."First thing i did was replace the batteries with 10 brand new AA Energizer batteries i bought at Kroger today. I read around and found some posts on weasner that some people may have been having trouble with the cable, so i tried plugging it in with a little force behind it and now i get past the motor fault message, but it always gets stuck at the "Testing Motors" prompt, and the motors never move.

Leave a Reply

Your email address will not be published. Required fields are marked *

One thought on “updating a meade 497 controller instructions”

  1. He couldn't move, the pain made his head hurt even more, almost making him throw up at the agony from his body."Aslan! Cool fingertips rubbed his forehead as he slowly regained the ability to think without his mind clouding with pain, the soft hand petting his face gently.